UA-44706117-1

Elcon CAN bus Adapter

Elcon CAN bus Adapter
(0)
model number Elcon-CAN-bus-Adapter
100 remaining
$105.00
Quantity
error text here
Twitter Email Google Plus
If your Elcon PFC charger has been programmed for CAN Bus control the CAN Bus adapter allows you to control the charger through a CAN bus signal from your BMS or other CAN bus controller. Pin 1 of the adapter must be connected to CAN-Lo from your BMS and pin 2 to CAN-Hi. If your BMS does not already have a 120 ohm termination resistor across CAN-Lo and CAN-Hi, you will need to add one. The charger expects to receive a message from the BMS with CAN ID 1806E5F4 and 8-byte data with the voltage and current requested every second. If the charger doesn't receive a valid CAN message in 5 seconds, it stops charging until it receives a valid CAN message. The charger sends out a CAN status message with voltage, current and status information every second. Up to 4 chargers with different CAN IDs 1806E5F4, 1806E7F4, 1806E8F4 and 1806E9F4 can be connected to the same CAN bus and be controlled by one BMS.

If you order a charger with a CAN bus adapter we do not need a charging algorithm. We only need to know:
1. The maximum safety voltage to set. The safe voltage is normally set just above the maximum charge voltage you need as a backup to the CAN controller.
2. The customer's primary use will be on 115VAC or 230VAC so we can program accordingly.
3. If the primary is a 115VAC circuit the customer wants to program for 15A or 20A draw from the wall outlet.
Write a Review
Review Submitted
Overall Customer Rating
Be the first to write a review.
Write a Review
choose a rating
enter a review title
enter a review description
LOADING

Share and Enjoy

  • Facebook
  • Twitter
  • Delicious
  • LinkedIn
  • StumbleUpon
  • Add to favorites
  • Email
  • RSS